corner flow
英 [ˈkɔːnə(r) fləʊ]
美 [ˈkɔːrnər floʊ]
拐角流
双语例句
- Influence of Edger Roll Shape on Corner Metal Flow
立辊形状对边角部金属流动的影响规律 - Due to narrow gallery and complex hydraulic flow pattern on the corner in the reciprocating baffled flocculation tank, it is very difficult to measure its flow field.
由于往复隔板絮凝池廊道狭窄、絮凝池拐弯水流结构复杂，致使整个流场的量测十分困难。 - Computational and experimental investigation of plasma aerodynamic actuation based corner flow separation control in a compressor cascade
等离子体气动激励抑制压气机叶栅角区流动分离的仿真与实验 - Comparison of Turbulent Models for Supersonic Compression Corner Flow
在超音速压缩角下的湍流模型数值比较 - The design scheme of book wrapping and corner making mechanism that influenced packing quality was analyzed beginning with the producing flow of paperbound packer.
从平装书籍打包机的工作流程出发，分析了影响包书质量的包书作角部件的结构设计方案。 - Influence of Mach number on tornado corner flow dynamics.
数对龙卷角流动力学的影响。 - Separation of Active Anthraquinone Ingredient in Chinese Rhubarb By High-Speed Countercurrent Chromatography; Computational and experimental investigation of plasma aerodynamic actuation based corner flow separation control in a compressor cascade
利用高速逆流色谱分离大黄活性成分等离子体气动激励抑制压气机叶栅角区流动分离的仿真与实验 - Effect of the configuration of the corner in a narrow rectangular channel on flow and heat transfer
矩形窄缝流道角部结构对流动和传热的影响 - Three-dimensional numerical simulation of the edger and corner metal's flow on edging rolling on roughing of hot continuous rolling process
热连轧粗轧调宽轧制过程边角部金属流动三维数值模拟 - The models are applied to four hypersonic complex flows with shock wave/ boundary layer interaction. These benchmark flows are: a 2 D supersonic compression corner flow, an ogive cylinder flare flow, and an oblique shock wave/ turbulent boundary layer interaction.
选择四个基准流动&超声速和高超声速二维压缩拐角、锥柱裙组合体绕流和斜激波/平板湍流边界层干扰进行了数值计算。 - The results show that a positive bowed blade can restrain the corner separation and change the separation configuration, while it can not avoid the flow separation on the suction surface.
结果表明，正弯可以有效遏止角区分离，改变吸力面的分离形态，但不能完全消除吸力面的分离。 - Finally, a new linear method is derived to determine the 3D motion and structure at each corner point from known optical flow field.
通过光流运动模型的建立，推导出由稀疏光流场重建三维物体运动和结构的线性方法。 - As suction flow rate increases, the accumulation of low energy fluid in the suction corner is alleviated, and the flow turning as well as the cascade load increases, therefore, total loss is reduced by 28.2% at most.
随吸气量增加，吸力面角区低能流体积聚明显减小，气流折转能力加强，叶栅负荷增加，总压损失降低最高达28.2%； - A linear method is derived to determine 3D structure and motion using corner point optical flow. The method has advantages over the traditional methods in algorithm.
在3D运动和结构重建方面，本文改进了基于光流场计算3D运动和结构的线性算法，通过光流运动模型的建立，推导出由角点光流场重建3D物体运动和结构的线性算法。 - The results show that the wake can be found in shroud/ suction corner and the jet does not exist near blade pressure side; the flow construction in the impeller did not prove to be the well known jet/ wake flow model.
试验表明，在前盖板／叶片吸力面拐角处存在尾流，但压力面不存在射流，叶轮内部流动结构与射流／尾流模型不符合。 - Simulated flow inside impeller illustrates the tip clearance and corner vortex developing and mixing with main flow through passage.
对叶轮内流动模拟，说明了叶顶泄漏流对主流的作用，以及叶轮内部壁角涡的形成与发展。 - Using the unified manner to flow vector corner singularity, the flow vector expressions for yield ( or failure) surface of the Rock Nonlinear Unified Strength Theory are derived in this paper.
本文采用流动矢量奇异性的统一处理方法，推导出岩石非线性统一屈服面（破坏面）的流动矢量表达式。 - FEM Analysis to the Slab Corner Metal Flow Condition During Multi-Pass V-H Rolling Process Research on the Corner Stress of Dog-Bone Shaped Workpiece During Flat-Spread Rolling
多道次立-平辊轧制轧件角部金属流动状态有限元模拟调宽轧制平轧过程轧件角部应力研究 - This thesis studies the prediction method of one street corner short time transportation flow and puts forward a mixed prediction method based on AR model and wavelet neural network.
本论文主要研究单一路口短时交通流的预测方法，提出了基于小波分解的AR模型和小波神经网络相结合的混合预测方法。 - The characteristics and law of the corner flow are presented, and comparision of the corner flow with the corresponding Prandtl-Meyer type expansion in two dimensional flat-plane case is emphatically made.
给出了该流动特征、规律、并着重与相应平面二维Prandtl-Meyer型膨胀流动作了对比，指出了二者异同之处。 - The cylindrical upstream influence region in the three dimensional interactions between shock wave and turbulent boundary layer induced by swept com-pression corner appears quasi two dimensional flow behaviors.
在后掠压缩角引起的三维激波边界层干扰中，柱形的上游影响区表现出准二维的流动特性。 - Along different category of tracks, the location and scope of "corner flow" and leeward trough were different.
不同台风路径下，角流和背风槽的位置和范围不同。 - In corner arrangement tangetial firing boiler, the existing of remaining whirl of furnace oulet gas flow would cause gas temperature deviation along the width direction in the horizontal gas pass, which would lead to local overheating and tube rupture in high temperature superheater.
四角布置切圆燃烧方式的锅炉，由于炉膛出口气流残余旋转的存在，引起水平烟道内烟气沿宽度方向烟温分布不均匀，导致高温过热器局部超温、爆管。 - The corner flow can carry small slices or blocks of eclogites embedded within mud or serpentinite matrix to move towards the surface, while lateral migration of subducted slab also plays certain role in the process of orogenic exhumation.
此外，楔角回流作用可驱使包裹在泥质/蛇纹岩楔中榴辉岩块向地表折返剥露，而且俯冲带迁移对于造山带剥露过程的驱动作用也不容忽视。 - Corner detection have been used in optical flow computation, motion estimate, object tracking, shape analysis, camera calibration, 3D reconstruction, location and measure of machine vision.
角点检测在光流计算、运动估计、形状分析、相机标定和3D重建、视觉的定位和测量等方面都有重要的应用； - The emulsion can make residue oil in the corner form, break and form a small residue oil drops which flow with the flow of emulsion and enhancing the oil replaced efficiency.
乳状液通过侧向推挤或者刮油使边缘及角隅残余油变形、拉断，形成小的残余油滴，随乳状液夹带运移，提高了驱油效率。 - With the 670 t/ h corner tangential boiler serving an object of study, reverse-tangent cases at tertiary air and OFA ( Over flow air) were performed by using combustion numerical simulation program.
利用燃烧数值模拟程序对一台670t/h四角切圆锅炉进行了三次风与OFA反切工况数值试验研究。 - Addition of Biased Secondary Air for Corner arranged Direct flow Burner
直流式角置燃烧器增设偏转二次风 - Chapter One mainly discusses the special subject orientation: the focus on the certain region in transitional society-city corner, the flow of the crowd-urban people.
第一章主要是论述贾樟柯电影作品的特殊题材取向：聚焦社会转型期的固定地域城镇角落，社会变革时期的流动人群城镇人群。 - Based on the results, the reactor with slant top was better than flat top, the high or low speed in local areas could be weakened by curved corner, the outlet with gradual change was more conducive to optimize flow field.
模拟结果表明反应器斜顶结构优于平顶，烟道采用弧形拐角以削弱局部高低速区，渐变出口形式更加有利于反应器内部流场的均匀。